Power Supply; Common Operation - Sanyo MCD-Z250F Instruction Manual

POWER SUPPLY
AC POWER OPERATION
Connect one end of the mains lead 10 [AC INPUT]
socket (Fig. 2) on the unit and the other end to the
AC outlet.
NOTES:
When the mains lead is connected to the unit,
the installed batteries will be automatically
disconnected.
- The FUNCTION switch is mounted on the
secondary side. The unit is not disconnected
from mains, even switched off.
BATTERY POWER OPERATION (Fig. 3)
1. Open the battery compartment lid by pushing
down on the tabs.
2, Install 8 "C" and 4 "AA size batteries (not
supplied). Refer to the polarity diagram on the
back
of the unit. Match the (+) and(-) marks on
the diagram to the (+) and (-) marks on the
batteries.
IMPORTANT NOTES:
l'ufwr memory txicbup hattiwles
If 4 "AA" cell batteries are installed, the
Tuner memory contents have been set will
be retained even if the power should fail or
the C batteries should run
down.
- When the mains lead is kept plugged into
the outlet (energized state), the
consumption of the memory back-up
battery power can be reduced.
3. Replace the lid.
CAUTION:
WHEN INSTALLING BATTERIES
To prevent battery electrolyte leakage, which
may result in injury and damage to the unit or
other objects, observe the following precautions:
1,
All batteries must be installed with the proper
polarity (388 dhfyiim ofi ih@ba?k bf tfw
unit).
2. Do not mix new with old or used batteries.
3. Only use batteries of the same lype and
brand.
4. Remove the batteries when they are not to
be used for a long period tirr=.
CD PLAYER/RADIO REMOTE
CONTROL
BATTERY INSTALLATION (Fig. 4)
1. Open the battery compartment lid.
2. Install 2 "AA size batteries (not supplied)
exactly as shown in the battery compartment.
3. Close (he lid.
Remote control range (Fig. 5)
CONTROLS (Fig. 6)
NOTE:
1.
2.
3.
4,
5.
6,
7.
The buttons on the remote control perform
similar functions to similarly marked buttons
on the unit,
PLAY/II PAUSE: Play/Pause button
STOP: Stop button
K< SKIP/SEARCH FM, - TUNING +:
CD Skip/Search and Radio Tuning buttons
BAND: Radio band button
MEMORY (CD/llf): CD~uner memory button
P, SCAN: Preset scan l?UNOn
(FM MODE) REPEAT: FM FTKXM2B i@eai
button
COMMON OPERATION
Adjusting the vofume
Turn [VOLUME].
Adjusting the tone
Turn [TONE].
Bass expander system
Press [BASSXPANDER] to ON to enhance the
bass sound.
Stereo headphones socket
IwM IIIB tfii~iplu~ ftbm tA
pair
bf headph~t%%t ( nbt
supplied) into the
[PHONES] socket. When the
headphones are plugged In, qwikers are
automatically disconnected.
7-J
i
0
z
u
i!