Charging The Batteries - Heiniger Saphir series Instruction Manual

fig. 10

6.1.2 Charging the batteries

fig. 11
fig. 12
fig. 13
10
1. Place the charging station on a firm,
even, dry, clean and free underground or
fix it on the wall by the suspension leads
on the back of the charging station (1)
(diameter of screw 4,5 mm).
2. Plug the charging station in the power
outlet.
3. The permanent light of the green LED
signalises, that the plug is connected
correctly to the power outlet and the
charging station is ready for use.
1. Test the contacts of the clipper (1) and
the battery (2) for foreign particles and
contamination.
2. Assure, that the switch of the clipper is
in OFF-position ("0") (fig. 4).
3. Insert the battery (2) in the clipper (3),
until the battery interlock (1) is engaged
on both sides.
4. Put the clipper with the inserted battery
(1) or spare battery (2) from above with-
out force into the provided charging
cavity of the charging station.
5. Await the charging time (3 Technical
Data).
6. Battery is charging. During the charging
time the control light is illuminating red
(3). As soon as the battery is fully char-
ged, the green control light will light
up and the charger will switch to trickle
charge.
Instruction Manual / Small animal clipper