SAGEMCOM F@ST 4310 Reference Manual page 144

5- Information / Configuration
Field
Auto Channel
Timer (min)
802.11n/EWC
Brandwidth
Control
Sideband
802.11n Rate
802.11n
Protection
Support 802.11n
Client Only
RIFS
Advertisement
OBSS
Co-Existance
RX Chain Power
Save
RX Chain Power
Save Quiet Time
RX Chain Power
Save PPS
Radio Power
Save
Radio Power
Save Quiet Time
Page 5-112
Action/Meaning
Configure the duration, in minutes, during which the router
must seek the best wireless channel. This option is only
available when the selection of the channel is configured in
Auto (Automatic).
Select Auto to enable the 802.11n standard and enjoy ideal
speeds for the digital home devices (HDTV, DVD, ...) to 270
Mbit/s.
Select the bandwidht 20 MHz or 40 MHz.
Select in the drop-down list the required value to specify if
the extension channel should be in the Upper or Lower
sideband.
Select in the drop-down list the Physical Layer (NPHY) rate
required.
Note: These rates are only available when the 802.11n
mode is set to Automatic.
The 802.11g standards provide a protection method in order
802.11g and 802.11b devices to coexist in the same network
without exchanging data at the same time.
• Select Off only if there is a possibility that 802.11b or
802.11g devices will use your wireless network.
• Select Auto for the wireless devices use RTS/CTS to
improve 802.11n performance in mixed 802.11g/802.11b
networks
Select On in the drop-down list to enable support for 802.11n
clients only.
Note: In this case, note that 802.11g and 802.11b clients will
not be able to connect to the network.
RIFS stands for Reduced Interframe Space. RIFS were
introduced with 802.11n
transmissions to the
SIFS-separated response is not required, such as a
transmission burst.
Select On in the drop-down list number of cases in which the
primary and the non-primary channels overlap.
Enabling this feature turns off one of the Receive chains.
The number of seconds the traffic must be below the PPS
value below before the Rx Chain Power Save feature
activates itself.
The maximum number of packets per seconds that can be
processed by the WLAN interface for a duration of Quiet
Time, described above, before the Rx Chain Power Save
feature activates itself.
Enabling this feature turns off one of the Transmit chains.
The number of seconds the traffic must be below the PPS
value below before the Radio Chain Power Save feature
activates itself.
Sagemcom Broadband SAS document. Reproduction and disclosure prohibited
to improve efficiency
same receiver in
Default
value
Auto
Auto
20 MHz
Lower
Auto
Auto
Off
Auto
for
which a
Enable
Disable
10
10
Disable
10
F@ST 4310 Reference Manual