Table of Contents
Advertisement
Install ball bearing as illustrated.
Bearing puller
EX: (Snap-on CJ 950
)
19,20,21, Bearing 6201, seal & distance ring
To remove bearing 6201, seals and distance ring use
pusher
(PI
N 420 876 510)
(I'ffij
/
To install ball bearing 6201 use ball bearing pusher
(PIN 420876 500),
O
NOTE: Ball bearing shielded side must be facing
rotary valve
.
SECTION 02 ENGINE
SUB-SECTION 07 (534 ENGINE TYPE)
20,21, Seals & distance ring
To install seals on water pump side proceed as follow:
Appl
y
some lithium grease or equivalent on seal lips.
Position all seals with shielded portion towards water
pump using pusher
(PI
N 420 876 510), Align distance
ring opening with crankcase draining hole (see note
and illustration). Push seals and distance ring assembl
y
against bearing.
O
NOTE: 35% of the distance between first and se-
cond seals must be filled with lithium grease or
equivalent.
O
NOTE: The draining hole is use to detect seals
malfunctions. If you notice oil, or coolant at the exit
of the draining hole, this mean that oil seal or coolant
seal leaks.
_
CAUTION: Failure to position the seals as speci-
... fied may provocate the seal spring to be corroded
by coolant. Severe damages will occur if these notices
are
disregarded .
.
PAGE 145
Hide quick links:
Advertisement
Table of Contents
