Roller; Shouldered Bushing; Shim - BOMBARDIER Skandic 377 IR Shop Manual

INSPECTION
Drive pulley should be inspected annually.
5,9, Inner & outer half
Check outer half for excessive lateral play and inner half
shaft for scratches.
12, Roller
Check for roundness of external diameter.
14, Shouldered bushing
Check for excessive wear .
ASSEMBLY
14, Shouldered bushing
Shouldered pin bushings must be installed in outer half
as per illustration.
10,11,12,13, Counterweight assy
Appl y Loctite 242 or equivalent on nut threads then tor-
que nuts to 14 N-m (10 ft-Ibs).
INSTALLATION
Lock crankshaft in position as explained in removal pro-
cedure . Make sure crankshaft is rotated 45° counter-
clockwise
from T. D. C. position and that cylinder is
completely filled with a starter rope.
9, Inner half
Lubricate lightly pulley shaft drive pulley lubricant PIN
413800700.
SECTION 03 TRANSMISSION
SUB-SECTION 03 (DRIVE PULLEY)
8, Shim (neutral)
This skim is used to obtain neutral function of the drive
pulley when engine is idling: use as required , maximum
of three (3). Refer to ADJUSTMENT.
1,4,5, Outer half
Pack pulley bore with drive pulley lubricant PI N 413
800 700.
Install governor cup correctly as per illustration making
sure that the rollers are sliding on their ramp .
_ CAUTION: Ensure rollers are in good condition.
. . Replace as required.
PAGE 203