Generating Coil Screws; Lighting Coil; Splice Connectors And Protector Tube; Lighting Coil Screws - BOMBARDIER Skandic 377 IR Shop Manual

SECTION 02 ENGINE
SUB-SECTION 06 (503 ENGINE TYPE)
~
CAUTION: Protect harness from flame.
- Remove screws (use Phillips no. 2 or suitable flat
screw driver)
- Cut the four wires as close as possible to the coil
body
- To pass new coil wires in harness, tape the old wires
to the end of new wires and pull them through the
harness protector tube
- Insert the new wires into the old connector housing
and install connectors
Insert
new wires
==:::~~~
~~~~~
_ CAUTION: Replace the old wires in the connec-
." tor with the same color coded new wires.
- Install a new receptacle connector to the black/-
yellow striped wire
- To install the ground connector of the armature
plate, tape the new black lead to the old one and pull
it under the lighting coil with the old wire
- Solder an eye connector to the lead and fasten it
under the wire retaining clip.
eye connector
4,7, Generating coil screws &
"Loctite 242"
- To install the new coil on the armature plate, remove
the shipping nuts from the coil and apply Loctite 242
(blue, medium strength) to screws before assembly
_ CAUTION: Before reinstalling the magneto,
." remove the loose epoxy from harness.
PAGE 122
5, Lighting coil
To replace lighting coil:
- Heat the armature plate around the screw holes to
break the Loctite bond (200° F)
Heat
Protect harness
from flame
CAUTION: Protect harness from flame.
- Remove screws (use Phillips no. 3 screwdriver)
- Remove the wire retaining clip from armature plate
9,10, Splice connectors and protector tube
- Pull out protector tubes and unsolder the splice con-
nectors
- Solder the yellow wire in the harness to the white
tube protected wire of the coil
- Solder the yellow/black striped wire in the harness to
the black tube protected wire of the coil
White protector with
yellow wire of harness
Black protector with
yellow/black wi re of harness
Position protector tubes over connections
6,7, Lighting coil screws
&
1/
Loctite 242"
Prior to assembly, apply "Loctite 242" (blue, medium
strength) on lighting coil screws.
- Fasten retaining clip onto protector tubes