Removal From Vehicle; Engine Support And Muffler Disassembly & Assembly; Installation On Vehicle - BOMBARDIER Skandic 377 IR Shop Manual

SECTION 02 ENG INE
SUB-SECTION 01 (247 ENGINE TYPE)
7. Metal screw B x
5/8 (2)
2. Washer (2)
3. Rubber spacer (2)
4. Air duct
5. Hexagonal screw
7/4
x 20
6. Washer
7. Stud MB x 79 (2)
B. Muffler gasket
9. Lockwasher B mm
(2)
70. Hexagonal nut B mm
(2)
77. Muffler
72. Hexagonal nut B mm
73. Retainer washer (2)
74. Rubber washer
75. Hexagonal screw MB x 25
76. Exhaust grommet
REMOVAL FROM VEHICLE
Remove or disconnect the following then lift engine from
vehicle .
- Console.
- Pulley guard.
- Drive belt.
- Muffler.
- Primer hose .
- Decompressor cable.
- Throttle cable.
- Fuel lines.
- Electrical connector .
- Separate steering column support at upper column.
- Engine mount nuts.
PAGE 18
77. Starter grip
7B. Rubber buffer
79. Distance sleeve
22
mm
(4)
20. Stud M70 x 42 (4)
27. Elastic stop nut 3/8-24 (4 )
22. Washer (4)
23. Elastic stop nut 5176-24 (4)
24. Engine support
25. Lockwasher 70 mm (4)
26. Hexagonal nut 70 mm (4)
27. Cross support (2)
28. Vibration damper (4)
29. Threaded spacer (4)
30. Carriage bolt 3/8-24 (4)
37. Knurled screw 5176-24 (4 )
32. Rotax engine 247
ENG INE SUPPORT AND MUFFLER
DISASSEMBLY & ASSEMBLY
10,23,26, M an ifold nuts, engine support
nuts & engine mount nuts
Torque the manifold nuts to 22 N· m (16 ft ·l bs)
Torque the engine support nuts to 31 N.m (23 ft - Ibs).
Torqu e the engine mount nuts to 35 N·m (26 ft · lbs).
INSTALLATION ON V EHICLE
To install engine on vehicle, inverse removal procedure .
However, pa y attention to the following .
- Check tightness of engine mount nuts, and drive pul -
ley bolt.
- After throttle cable installation, check maximum throt-
tle slide opening.
- Check pulley alignment and drive belt tension.