Armature Plate - BOMBARDIER Skandic 377 IR Shop Manual

The ground terminal from generating coil must be
fastened under th is clip.
_ CAUTION: Before reinstalling magneto, remove
'Y
the loose epoxy from harness.
ASSEMBLY
1, Armature plate
Position armature plate on crankcase, aligning marks
on both parts .
7, "Loctite 242"
Clean crankshaft extension taper .
Apply "Loctite 242" (blue medium strength) on taper .
11,19, Flywheel, lockwasher 22 mm,
woodruff key
Position woodruff ke y, magneto flywheel and
lockwasher on crankshaft.
7,20, "Loctite 242" & nut
Clean nut threads and apply "Loctite 242" (blue, me-
dium strength) before tightening nut to 85 N.m (63
ft.lbs).
8,21,25,27, Harness, C.D. Box, Ignition
coil & spark plug protectors
At reassembly coat all electric connections with
silicone dielectric grease ' to prevent corrosion or
moisture penetration .
_ CAUTION: Do not use silicone "sealant", this
'Y
product will corrode contacts.
O
NOTE: For ignition timing procedure refer to "ig-
nition timing" section 04 sub-section 02.
SECTION 02 ENGINE
SUB-SECTION 06 (503 ENGINE TYPE)
PAGE 123