Engine Support And Muffler Assembly - BOMBARDIER Skandic 377 IR Shop Manual

SECTION 02 ENGINE
SUB-SECTION 02 (277 ENGINE TYPE)
7. Engine Rotax
277
2. Gasket (2)
3. Air deflector
4. Exhaust socket
5. Lockwasher B mm
(2 )
6. Allen screw MB x 30. (2)
7. Spring (6)
B. Exhaust elbow
9. Elastic stop nut 70. mm
70.. Washer 70.,5 (3)
7 7. Rubber mount
72. Bushing (3)
73. Engine bracket
REMOVAL FROM VEHICLE
Remove or disconnect the following then lift engine from
vehicle.
- Pulley guard and drive belt
- Muffler
- Throttle cable and intake silencer
- Oil and fuel lines
- Oil injection pump cable
- Pulsation line
- Decompressor cable (applicable from engine number
3,376 ,858)
- Electrical connectors
- Hood retaining cable
- Bolts (3) securing engine support to chassis
ENGINE SUPPORT AND MUFFLER
ASSEMBLY
6,16, Exhaust manifold bolts & crankcase to
engine support bolts
Torque to 22
N-m (16
ft-Ibs).
9,14, Engine support nuts & bolts
Torque to 55 N-m (40 ftelbsl.
INSTALLATION ON VEHICLE
To install engine on vehicle, inverse removal procedure .
However, pay attention to the following:
- Check tightness of engine mount nuts, and drive pul-
ley bolt.
- After throttle cable installation, check carburetor max-
imum throttle slide opening.
- Check pulley alignment and drive belt tension.
PAGE 30
74. Hexagonal cap screw M7a x 45 (3)
75. Lockwasher B mm
(6)
76. Hexagonal cap screw MB x 20. (6)
77. Cup (2)
7B. Lockwasher 70. mm
(2)
79. Spring
20. Washer
27. Spring (2)
22. Muffler
23. Hexagonal cap screw M6 x 40.
24. Muffler suppon
25. Spring
26. Hexagonal flanged elastic stop nut 6 mm