V-Belt Pulley And Starting Pulley; Magneto Housing Flywheel; Generating Coil - BOMBARDIER Skandic 377 IR Shop Manual

CLEANING
Clean all metal components in a non-ferrous metal
cleaner.
_ CAUTION: Clean armature and magneto using
.". only a clean cloth.
DISASSEMBL Y
15,16, V-belt pulley and starting pulley
To gain access to magneto assembly, remove:
rewind starter;
starting and V-belt pulleys
O
NOTE: Before disassembling magneto plate, in-
dexing marks should be located to facilitate re-
assembly.
20, Flywheel retaining nut
To remove magneto flywheel retaining nut:
- lock crankshaft with crankshaft locking tool (PI N
420 876 640) as illustrated (magneto side piston
must be at top dead center);
- remove magneto retaining nut.
1 1 1 1 .
\111
/1
tLJj
\
'\
\
Crankshaft
locking tool
PIN 420 876 640
O NOTE: It should be noted that to correctly remove
a "Loctite" locked fastener it is first necessary to
tap on the fastener to break "Loctite" bond. This will
eliminate the possibility of thread breakage.
SECTION 02 ENGINE
SUB-SECTION 06 (503 ENGINE TYPE)
11, Magneto housing flywheel
To remove magneto housing (flywheel) :
- lock crankshaft with crankshaft locking tool (service
tool) and adjust magneto housing puller and puller
ring (service tool) as illustrated;
o
NOTE: For the above procedure, the locking type
puller can be used without crankshaft locking
tool.
PIN 420 876 065
PI N 420 876 080
- tighten puller bolt and at same time, tap on bolt head
using a hammer to release magneto from its taper.
REPAIR
2, Generating coil
To replace generating coil:
- Heat the armature plate around the screw holes to
break the Loctite bond (200
0
F).
Protect harness
from flame
PAGE 121