b.
Remove the brackets (2) from the hard drive.
Reverse this procedure to reassemble and install the hard drive.
Power button board
Description
Power button board (includes cable)
Before removing the power button board, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
a.
Service door (see
b.
Optical drive (see
c.
Top cover (see
Remove the power button board:
1.
Turn the top cover upside down, with the front toward you.
2.
Remove the Phillips PM4.5×2 broadhead screw (1) that secures the power button board to
the top cover.
Battery on page
37), and then remove the following components:
Service door on page
38)
Optical drive on page
Top cover on page
47)
40)
Component replacement procedures
Spare part number
767254-001
53