Table of Contents
Advertisement
STEP 2A INSTALLATION WITH
HOUSEHOLD WATER
FILTRATION SYSTEMS
Skip this step if you do not have a household
water filtration system.
If the water supply to the refrigerator is from any
household water filtration system, the filter cartridge
should be removed. For better ice and water
performance, remove the filter and install the filter
bypass plug.
Rotate
Clockwise
To Remove
STEP 3 INSTALL SIDE PANELS
Skip this step when not using side panels
If you are using 6 mm side panels, they should be
inserted into the case trim. Fasten the panels to the
refrigerator with stick-on hook and loop fastener
strips before setting refrigerator in place.
Installation Instructions
Filter
Bypass
Plug
STEP 4 INSTALL ANTI-TIP BRACKETS
WARNING:
The refrigerator is top-heavy and must be secured to
prevent the possibility of tipping forward.
ATTENTION:
BASCULEMENTS
Le réfrigérateur est beaucoup plus lourd en haut et il
faut le maintenir en place pour éviter la possibilité de
son basculement vers l'avant.
• Cut a 50 mm x 100 mm x 900 mm timber block.
Secure the block to the mounting brackets provided
using 6 mm wood screws.
50 x 100 mm
Cut 900 mm
Length
• Secure the bracket with timber block to the back
wall so that it is 2134 mm (or your installation
height) from the finished floor. Use 6 mm wood
screws.
Block
Brackets
Required
• Screws must penetrate at least 25 mm into vertical
wall studs.
Important Note: When the refrigerator is installed under a soffit or if
there is not enough height for this method of security, brackets cannot
be used. Proceed to step 6 to level the refrigerator and then to step 7
to secure refrigerator to cabinets. The refrigerator must be secured to
prevent tipping.
12
ANTI-TIP PRECAUTIONS
PRECAUTIONS CONTRE LES
Mounting
Installation
Bracket
Height
From Floor
Screws Mounted into
Vertical Wall Studs
Soffit
Brackets
Not Required
Beneath a
Soffit
Height
From
Floor
to
Bottom
of Wood
Block
Side View
Advertisement
Table of Contents
