Roll Paper Cannot Be Inserted Into The Paper Feed Slot; Cannot Load Sheets; Paper Is Not Cut Neatly - Canon iPF840 User Manual

Roll paper cannot be inserted into the Paper Feed Slot

8
Lower the Release Lever and close the Top Cover.
9
In a crouching position, push the Roll Unit in.
10
Position the Wheeled Output Stacker by the printer. (See "Using the Wheeled Output Stacker.")
11
Turn the printer on. (See "Turning the Printer On and Off.")
Roll paper cannot be inserted into the Paper Feed Slot
Roll paper cannot be inserted into the Paper Feed Slot
The roll paper is warped.
Paper is jammed by the paper feed slot.
The paper source selection is incorrect.
If paper cannot be advanced from Roll 2 (Lower),
the Roll Unit Cable is disconnected.

Cannot load sheets

Cannot load sheets
Cause
The paper source selection is incorrect.

Paper is not cut neatly

Paper is not cut neatly
612
The paper is bent or curled at the cut position.
Paper rises by the ends of the cut position be-
fore it is cut.
You are using paper that cannot be cut with the
Cutter Unit.
Cause
Press the Load button and select the paper source.
Cause
Straighten out any curling by the edges of the paper.
Reload the paper correctly.
Specify Manual in Cutting Mode in the Control Panel menu and use scissors or
a cutting tool to cut the roll after printing.
P.17
➔
Straighten out curls and reload the roll.
Remove the jammed paper.
(See "Clearing Jammed Roll Paper.")
(See "Clearing a Jammed Sheet.")
Press the Load button and select the paper source.
Connect the Roll Unit Cable firmly to the Roll Unit Power Supply Inlet and the
inlet on the roll unit.
Corrective Action
(See "Specifying the Cutting Method for Rolls.")
Corrective Action
P.605
➔
P.608
➔
Corrective Action
P.360
➔
iPF840
P.375
➔
User's Guide