Canon iPF840 User Manual page 446

Menu Settings
Paper Details
Paper Details
Keep Paper Type
*1:For information on the types of paper the printer supports, refer to Paper Reference Guide.
(See "Displaying the Paper Reference Guide.")
The types of paper indicated in the printer driver, related software, and the printer Control Panel as well are updated when you
install the printer driver from the User Software CD-ROM or if you update the information about the paper by using the Media
Configuration Tool.
446
(See "Updating paper information.")
Ink Menu
Rep. Ink Tank
Setting Item
(The type of pa- Trim Edge First
per is displayed
here.)( *1 )
CutDustReduct.
VacuumStrngth
Scan Wait Time
Roll DryingTime
NearEnd
RollMrgn
NearEnd Sht
Mrgn
BordlessOver-
size
Width Detection
Return Defaults
}
P.338
➔
Setting Item
(See "Cutting the Leading Edge of Roll Paper Automatical-
ly.")
P.366
➔
If you choose On, a line will be printed at the cut position when
paper cutting is selected. This option reduces the amount of deb-
ris given off after cutting. It also helps prevent adhesive from stick-
ing to the cutter and keeps the cutter sharp if you use adhesive
paper. (See "Reducing Dust from Cutting Rolls.")
Specify the level of suction that holds paper against the Platen.
(See "Adjusting the Vacuum Strength.")
Specify the time to wait for the ink to dry between each scan (after
the printhead finishes moving in one direction), in consideration of
how quickly the ink dries. Also specify the applicable area for the
ink drying time. Select Entire area to apply the ink drying time af-
ter each scan until the document is fully printed. Select Leading
edge to apply the ink drying time after each scan only in the area
110–160 mm from the leading edge. (The applicable length varies
depending on the Print Quality setting.) Note that printing will
take longer if you specify the Scan Wait Time setting. In particu-
lar, when Leading edge is selected, colors may be uneven in the
boundary between the areas with and without a drying time.
Specify the time to wait for the ink to dry for each sheet.
Specify the minimum margin at the leading edge of roll paper to
ensure better printing quality at the leading edge.
Note that if you choose 3mm, it may lower the printing quality at
the leading edge and affect feeding accuracy. The printed surface
may be scratched, and ink may adhere to the leading edge. It may
also cause the Platen to become soiled.
Specify a margin at the leading edge of sheets to ensure better
printing quality at the leading edge.
Note that if you choose 3mm, it may lower the printing quality at
the leading edge and affect feeding accuracy. The printed surface
may be scratched, and ink may adhere to the leading edge.
Select the amount of oversize extension of the original during bor-
derless printing.
Normally, we recommend that you set this to Standard.
If it is set to Little, although it will reduce soiling on the back sur-
face, white patches may remain on the printed surface.
Specify this option to print inside boundaries or in other cases
when specifying a particular starting position for printing.
Paper width and skew are not detected if you select Off. If paper
is loaded askew, paper jams or Platen soiling may occur.
Choose OK to restore Paper Details to the default values.
Print the paper settings as specified in Paper Details.
Select On when printing on a particular type of paper regularly.
(See "Changing the Type of Paper.")
P.335
➔
Replace the Ink Tank at this point. Follow the instructions dis-
played to complete the required procedure. (See "Replacing
Ink Tanks.")
P.566
➔
Description, Instructions
➔
P.564
➔
P.350
➔
Description, Instructions
iPF840
P.367
User's Guide