Preparing to Transfer the Printer
Other Maintenance
Other Maintenance
Preparing to Transfer the Printer ..................................................................................................................... 594
Reinstalling the Printer .................................................................................................................................... 599
Updating the Firmware ................................................................................................................................... 602
Preparing to Transfer the Printer
Preparing to Transfer the Printer
To protect the internal parts in transit, always follow these steps before transferring the printer to a new location.
Refer to the Setup Guide for details on packing the printer and installing it after transfer.
•
Be sure to contact your Canon dealer before transferring the printer to a new location. Ink may leak and damage
the printer if you do not prepare the printer correctly and it is tipped or stood on end in transit.
Important
•
Depending on the state of the printer, part replacement may be necessary when preparing to transfer the printer
(that is, when you execute the printer menu item to prepare for transfer).
Note
•
Ink must be drawn into the Maintenance Cartridge before Level 2 or Level 3 printer transfer, as described in the
following table. Prepare the Maintenance Cartridge in advance.
•
Always follow the instructions of the service representative when transferring the printer under Level 3 conditions.
Level
1
2
3
*1:This is the number of new Maintenance Cartridges required when you execute the Prep.MovePrinter menu.
The number varies depending on the amount remaining in the Maintenance Cartridge being used.
*2:If a message instructing you to replace the Maintenance Cartridge is displayed on the Display Screen, the
Maintenance Cartridge needs to be replaced.
594
Remove paper
1
Disassemble and repackage the Wheeled Output Stacker by following the installation procedure in reverse.
2
Remove the paper.
•
Rolls (See "Removing the Roll from the Printer.")
Transport
and Storage
In Low Tem-
Permitted Angle of Inclination
perature En-
vironments
No
Lengthwise: 0–30º
Rotation: 0–10º
Yes
All directions: 0–30º
Yes
Lengthwise: 0–90º
Rotation: 0–30º
Required
Amount of Ink to
Maintenance
Dispose of
Cartridg-
es( *1 )
0( *2 )
Approx. 700
1 or 2
ml (20.3 fl oz)
Approx. 700
1 or 2
ml (20.3 fl oz)
P.352
➔
iPF840
Usage Examples
Moving Within a Room
and Storage In Room
Temperature Environ-
ments
Transport By Vehicle
Move by temporarily
standing vertically
User's Guide