Operation Mode Parking - Husqvarna 420 Operator's Manual

CONTROL PANEL
If the robotic lawnmower charges in Secondary Area
mode, it will fully charge, drive out about 50 cm and then
stop. This indicates that it is charged and ready to start
mowing.
If the main working area has to be cut after charging, it
is appropriate to switch the operating mode to Main Area
before placing the robotic lawnmower in the charging
station.
Override timer
Any timer settings made can be temporarily overridden
by selecting Override Timer. It is possible to override the
timer for 24 hours or 3 days.
Spot cutting
Spot cutting means that the robotic lawnmower operates
in a spiral pattern to mow the lawn in the area it was
started. When it is finished, the robotic lawnmower
will automatically go to Main Area or Secondary Area
operating mode.
This is a useful function to quickly cut down the lawn in an
area that has been cut less often than other areas in the
yard.
The Spot Cutting function is activated with the START
button. It is possible to select how the robotic lawnmower
is to operate after mowing by pressing Right arrow and
then selecting Main Area or Secondary Area.

5.2 Operation Mode Parking

When the PARK button is pressed, the following operating
modes can be chosen.
Parked until further notice
The robotic lawnmower stays in the charging station
until another operating mode is selected by pressing the
START button.
3012-1223
Start again in 3 hours
The robotic lawnmower stays in the charging station for
three hours and then returns automatically to normal
operation. This operation selection is suitable when there
is a need to pause operation, e.g. for temporary irrigation
or for games on the lawn.
Start with next timer
The robotic lawnmower stays in the charging station until
the next Timer setting permits operation. This operation
selection is suitable if one wishes to cancel an ongoing
mowing cycle and allow the robotic lawnmower to stay in
the charging station until the next day.
English - 39
1157866-26,420,430X,450X,EN_160314.indd 39 2016-03-14 16:58:58