Husqvarna 420 Operator's Manual page 21

IMPORTANT INFORMATION
The low voltage cable must not under any
circumstances be shortened or extended.
It is possible to let the low voltage cable cross the working
area. The low voltage cable must be pegged down or
buried, and the cutting height should be such that the
blades on the blade disc can never come in contact with
the low voltage cable.
Make sure to lay the low voltage cable along the ground,
fastened with pegs. The cable must lie close to the
ground so as not to be cut before the grass roots have
grown over it.
The low voltage cable must never be stored coiled up
or lie under the charging station bottom plate as it may
cause signal interference from the charging station.
IMPORTANT INFORMATION
Place the low voltage cable so that the
blades on the blade disc can never come
in contact with it.
The power supply must be placed where it is well
ventilated and is not exposed to direct sunlight. The
power supply should be placed under a roof.
It is recommended to use an earth fault-breaker when
connecting the power supply to the wall socket.
The power supply must be mounted on a vertical surface,
such as a wall or a fence. Screw the power supply in
place with screws in the two mounting eyelets. No screws
are supplied. Select screws suitable for the material in
question.
Do not, under any circumstances, mount the power
supply at a height where there is a risk it can be
submerged in water (at least 30 cm from the ground). It is
not permitted to place the power supply on the ground.
Never connect the power supply to an electrical socket
if the cable or the connector is damaged. Damaged or
entangled cords increase the risk of electric shock.
IMPORTANT INFORMATION
Use the power supply plug to shut down
the charging station, for instance before
cleaning or repairing the search wire.
1157866-26,420,430X,450X,EN_160314.indd 19
INSTALLATION
min 30cm/12" min 30cm/12"
English - 19
3018-085
3018-085
3018-094
2016-03-14 16:58:28