Husqvarna 420 Operator's Manual page 32

If the guide wire has to be installed on a steep
slope, it is an advantage to lay the wire at an
angle to the slope. This makes it easier for the
robotic lawnmower to follow the guide wire on the
slope.
Avoid laying the wire at sharp angles. This can
make it difficult for the robotic lawnmower to follow
the guide wire.
6. Run the guide wire to the point on the boundary
wire where the guide wire is to be connected.
Lift up the boundary wire. Cut the boundary wire
using for instance a pair of wire cutters. Connecting
the guide wire is easier if a loop is made on the
boundary wire as described above, see Loop for
connecting the guide wire on page 25.
7. Connect the guide wire to the boundary wire using
a coupler:
Insert the boundary wire into each of the holes
in the coupler. Insert the guide wire in the center
hole in the coupler. Make sure the wires are fully
inserted in the coupler by checking that the ends
are visible through the transparent area on the
opposite side of the coupler.
Use pliers to completely depress the button on the
connector.
It does not matter which holes are used to connect
each wire.
8. Peg down/bury the connector in the lawn.
IMPORTANT INFORMATION
The guide wire may not cross the bound-
ary wire, for instance a boundary wire that
is laid out to an island.
English - 30
1157866-26,420,430X,450X,EN_160314.indd 30
INSTALLATION
135º
135º
90º
3012-560
3023-015
3018-055
3023-016
2016-03-14 16:58:48