Charging The Battery - Husqvarna 420 Operator's Manual

Installation and Connection of the Charging
Station
1. Position the charging station in a suitable spot.
2. Tilt the protective cover on the charging station
forward and connect the low voltage cable to the
charging station.
3. Connect the power supply's power cord to a
100-240V wall socket.
4. Fasten the charging station to the ground using
the supplied screws. Ensure the screws are
screwed all the way down in the countersink. If
the charging station is placed against a wall, it is
best to wait before securing the charging station
to the ground until after all the wires have been
connected.
IMPORTANT INFORMATION
It is not permitted to make new holes in
the charging station's plate. Only the exist-
ing holes may be used to secure the base
plate to the ground.
IMPORTANT INFORMATION
Do not tread or walk on the charging sta-
tion plate.

3.3 Charging the Battery

As soon as the charging station is connected, it is
possible to charge the robotic lawnmower. Set the main
switch in position 1.
Place the robotic lawnmower in the charging station to
charge the battery while the boundary and guide wires are
being laid.
If the battery is flat, it will take around 80 to 100 minutes
to fully recharge it.
IMPORTANT INFORMATION
The robotic lawnmower cannot be used
before the installation is complete.
English - 20
1157866-26,420,430X,450X,EN_160314.indd 20
INSTALLATION
3012-1090
3012-1093
3012-1063
3012-1045
3012-1046
2016-03-14 16:58:31