Husqvarna 420 Operator's Manual page 62

Corridor width > Guide
The Automatic passage management function
automatically adjusts the width of the guide corridor. The
maximum corridor width can also be changed manually.
The corridor width can be set to between 0 and 9.
If value 0 is specified, the robotic lawnmower will straddle
the guide wire meaning it runs right over the middle of the
guide wire.
Use the arrow keys to specify the required value.
The factory setting is 9.
Exit angles
Normally the robotic lawnmower leaves the charging
station in a direction within the 90°-270° exit sector. By
changing the exit angles, it makes it easier for the robotic
lawnmower to reach the largest working area if the
charging station is placed in a passage.
Exit angles > Sectors
The robotic lawnmower can be set for one or two exit
sectors. If the charging station is placed in a passage, two
exit angles, for instance 70°–110° and 250°–290°, can be
used.
When two exit angles are used, there is a need to also
specify how often the robotic lawnmower must leave
the charging station in sector 1. This is done using the
Proportion first function by specifying a percentage.
For instance 75 % means that the robotic lawnmower
leaves the charging station in Sector 1 on 75 % of the
times and 25 % of the times in sector 2.
Use the number keys to specify the required angles in
degrees for the sectors and proportion as a percentage.
Reversing distance
This functions allows you to control how far the robotic
lawnmower has to reverse out of the charging station
before it starts mowing. This is a useful function, for
instance, if the charging station is placed a long way in
under a veranda or in another limited space area.
Use the number keys to specify the required reverse
distance in centimeters and press OK.
Drive past wire
The front of the robotic lawnmower always passes the
boundary wire by a specific distance before the mower
turns around. The default distance is 31 cm, but this can
be changed if required. A figure between 20 and 50 can
be selected.
Note that the distance given is only an approximate value
and should be regarded as a guide. In reality, the actual
distance the robotic mower passes the boundary wire can
vary.
Specify the number of centimeters you want the robotic
lawnmower to pass the boundary wire and press OK.
English - 60
1157866-26,420,430X,450X,EN_160314.indd 60
MENU FUNCTIONS
3012-1446
3012-1418
3012-1419
3012-1447
2016-03-14 16:59:43