Table of Contents
Advertisement
LOCKING SCREW
Figure 9
4
The MSAM cardholders are now accessible. Each cardholder consists of a
hinged tilt-up cover attached to a connector base.
5
To unlock a cardholder, slide its locking plate to the unlocked position, shown
by the OPEN arrow (see
Figure 10
6
Open the cardholder by pivoting the cover on its hinges away from its
connector base (see
Figure 11
7
Remove any previously-installed MSAM card by sliding the card from the
cover.
8
Install an MSAM card by aligning the card and carefully sliding it within the
guides on the cover until it is fully inserted.
Before inserting the MSAM card, position it as shown in
NOTE
gold contacts facing the smart car reader end of the terminal. The cardholder
connector base has a set of contacts and a notch post on one corner to ensure the
MSAM card is positioned correctly when the cover is closed. The MSAM card has
a notch on one corner to ensure that it fits into the connector base in only one way.
MSAM Compartment Door and Locking Screw
Figure
MSAM Cardholder Close-Up
Figure
11).
OPENING THE
REMOVING A
CARDHOLDER
SAM CARD
Using an MSAM Cardholder
10).
INSTALLING A
SAM CARD
Figure
O
MNI
T
S
ERMINAL
ETUP
Install/Replace MSAM Cards
MSAM
COMPARTMENT
DOOR
CLOSING THE
CARDHOLDER
11, with the card's
37
I
G
XX
NSTALLATION
UIDE
17
Advertisement
Table of Contents
