Table of Contents
Advertisement
T
S
ERMINAL
ETUP
Routing The Cables Using Wire Clips
Routing The
Cables Using
Wire Clips
Smart Card
Transaction
22
O
37
I
MNI
XX
NSTALLATION
Since the Omni 37xx terminal is a hand-over solution, make sure the cables are
routed loosely. Use the two wire clips provided with each terminal to organize
loose cables. See
Figure
Figure 15
Routing Cables Using Cable Wires
1
Place the telephone cord and power cable into the grooves inside the wire
clip.
2
Close the wire clip and press the halves together until the it snaps closed.
3
Unsnap the wire clip, to reposition as necessary.
The smart card transaction procedure may vary from one application to an
another. Verify with your application provider before you perform a smart card
transaction.
To Conduct a Smart Card Transaction
1
Position a smart card with the contacts facing upward (see
2
Insert it into the smart card reader slot in a smooth, continuous motion until it
seats firmly.
G
UIDE
15.
Figure
16).
Advertisement
Table of Contents
