Drive Chain - BOMBARDIER DS 250 Operator's Manual

Install the new bulb by first pushing
in while turning clockwise. Reinstall
lens.
Direction Signal Lights Bulb
Replacement
Remove lens retaining screw.
vmo2009-003-001_a
Tilt lens as shown to unlock it from
housing.
vmo2009-003-002_a
Push bulb in while turning it coun-
terclockwise to release bulb from its
socket.
Push the new bulb in while turning it
clock wise to lock bulb into its socket.
Headlights Beam Aiming
To adjust beam, proceed as follows.
Loosen the bolts shown on the fol-
lowing illustrations but do not remove
them.
vmo2009-002-002_a
1. Bolts to be loosened
Adjust headlight housing angle by
hand.
Adjust both headlights evenly.
Tighten bolts when proper adjustment
is reached.

Drive Chain

Adjust and lubricate drive chain before
each use.
Place ignition switch to the OFF
position before checking, adjust-
ing or lubricating the drive chain.
NOTICE
cle with the drive chain too loose or
too tight as severe damage to the
drive components can occur.
Drive Chain Inspection
This vehicle is equipped with O-ring
sealed permanently greased pins and
rollers. Before operating the vehicle,
always inspect the drive chain.
_______________
MAINTENANCE PROCEDURES
WARNING
Never operate this vehi-
93