Table of Contents
Advertisement
STORAGE
It is during summer. or when a vehicle
is not in use for any length of time, that
proper storage is a necessity. Storage
of the snowmobile during long period
of inactivity consists of checking and
replacing
rnissinq, broken or worn
parts; proper lubrication and treatment
to insure that parts do not become
rusted, cleaning items such as carbure-
tor of oil mixtures, to prevent gum var-
nish formation within the carburetor,
and in general, preparing the vehicle so
that when the time comes to use the
snowmobile again it will start and be in
top condition .
..... WARNING: Only perform such
..... procedures as detailed in this
manual. It is recommended that dealer
assistance be periodically obtained on
other components / systems not cov-
ered in this manual. Unless otherwise
specified, engine should be turned OFF
for all lubrication and maintenance pro-
cedures.
Track
Inspect the track for wear, cuts, miss-
ing track guides and broken rods.
Make any necessary replacement.
..... WARNING: Do not operate a
..... snowmobile with a cut, torn or
damage track.
Lift the rear of the vehicle until the
track is clear of the ground, then sup-
port it with a brace or trestle. The
snowmobile should be stored in such a
way that the track does not stay in
contact with the ground.
O
NOTE: The track should be rota-
ted periodically
I
(every 40 days).
Do not release track tension.
tIP
CAUTION:
To
prevent
track
... damage, temperature in the stor-
age area must not exceed 38
0
C
(100°F).
28
Suspension
Bogie Wheels
Remove the bogie wheel sets. Remove
the cross shaft from each bogie wheel
set. Clean the bogie wheel assembly
and shaft of dirt and rust. Check the
condition of the cross shaft, replace if
worn. Apply a coat of low temperature
grease over the shaft.
Grease each set then spray the springs
with metal protector, or wipe with an
oil soaked cloth. Assemble and install
each set in the proper position.
Torque cross shaft bolts to 30 N.m (23
ft-lbs) .
Ski
Wash or brush all dirt or rust accumu-
lation on the skis and springs. Grease
the ski leg grease fittings. Check the
condition of skis, ski runners and leaf
springs. Replace if worn or weak.
Controls
Lubricate the steering mechanism. In-
spect all components for tightness,
(spring coupler bolts, steering arm
locking bolts, tie rods, ball joints, etc.).
Tighten if necessary. Oil moving joints
of the brake mechanism.
..&.
WARNING:
Do
not
lubricate
..... throttle and /
or brake cable
housing. Avoid getting oil on brake
pads.
Coat
electrical
connections
and
switches with a greaseless metal pro-
tector. If unavailable, use petroleum
jelly.
Hide quick links:
Advertisement
Table of Contents
