Error Message - Toshiba e-studio191f Service Manual

8.4.

Error Message

8.4.1. Error Message Sent to the Sender
Error messages that are emailed from your machine to the original sender during remote programming of
the Auto Dialer via email.
Error Message
1 554 Data Transfer Error (broken Header) The header or sub header decoding is being processed
2 554 Data Transfer Error (broken Data)
3 554 Data Transfer Error (FAX module)
4 554 MIME attachment not supported
(message/file)
5 554 MIME format not supported
6 554 G3 Relay permission denied
7 554 Relay Address unknown
8 554 Memory Full (FAX module)
9 554 Data Transfer Error
8.4.2. Internet Fax Return Receipt Error Messages
Error messages that are printed on the Internet Fax Return Receipt when remote programming of the Auto
Dialer via Email fails.
Error Message
1 Format Error : <@command block, the
"@end" command is missing.>
2 Format Error : <@begin block, the
"@begin" command is missing.>
3 Format Error : <@begin block, the
"@end" command is missing.>
4 Format Error : <@system block, the
"@end" command is missing.>
5 Format Error : <@sender block, the
"@end" command is missing.>
6 Format Error :<@domain block, the
"@end" command is missing.>
7 Format Error : <@program block, the
"@end" command is missing.>
8 Format Error : <@system block, the
"@system" command is missing.>
9 Permission denied : <054 Fax
Forward parameter is set to "Valid".>
10 Permission denied : <Fax machine is
busy performing a task.>
Possible Cause / Action
while the message finished, try again.
Multiple contents are present and being processed while
the message finished, try again.
Data transfer error occurred in the FAX module while
communicating with the LAN module, try again.
MIME attachment is not supported during this operation,
resend using plain text in the message body only.
MIME file type is not supported, resend using plain text in
the message body only.
The requested domain for Relayed Transmission is not
registered.
The telephone number of end receiving station for the
Relayed Transmission is unknown.
FAX Memory is full, try again later.
Other errors not listed above, try again later.
Possible Cause / Action
The block termination command "@end" is missing in the
"@command" block, add the "@end" command and try
again.
The block start command "@begin" is missing in the
"@begin" block, add the "@begin" command and try again.
The block termination command "@end" is missing in the
"@begin" block, add the "@end" command and try again.
The block termination command "@end" is missing in the
"@system" block, add the "@end" command and try again.
The block termination command "@end" is missing in the
"@sender" block, add the "@end" command and try again.
The block termination command "@end" is missing in the
"@domain" block, add the "@end" command and try again.
The block termination command "@end" is missing in the
"@program" block, add the "@end" command and try again.
The system block start command "@system" is missing in
the "@system" block, add the "@system" command and try
again.
Set the Fax Forward parameter to "Invalid".
Try again later when the machine is not busy.
213
DP-1910F