Information Code Table (For Facsimile)131 - Toshiba e-studio191f Service Manual

4.8. Information Code Table (For Facsimile)
Code Mode Phase
001 RCV C, D
COPY
002 RCV C, D
COPY
007 RCV C, D
COPY
008
010 RCV B, C
COPY
011 STANDBY B, C
012 RCV C, D
017
030 XMT
031 XMT
COPY
041 STANDBY B, C,
RCV
COPY
043 STANDBY B, C,
RCV
COPY
045 STANDBY
060 -
061 -
302 XMT B, C,
RCV
400 XMT
Fax Information Codes
Description of Problem
Leading edge of the recording paper
fails to reach the Timing Sensor.
(1st Tray)
Leading edge of the recording paper
fails to reach the Timing Sensor. (2nd
Tray)
1. Leading edge of the recording
paper fails to reach the Paper Exit
Sensor.
2. Recording paper has not
completely passed the Paper Exit
Sensor.
Paper Tray is opened while paper is
feeding.
No recording paper.
Paper Tray is not installed properly.
The length of the received document
is over 2 m.
Incorrect paper size loaded in the
Paper Tray.
B Read Point Sensor does not go ON
within 10 seconds after the document
starts feeding.
C Transmitting document was longer
than 2 meter (or 78.7 in).
Out of Toner.
D
Low Toner.
D
- No Toner Cartridge.
A Printer Cover is open.
A ADF Door is open.
No response of 2nd G3 PCB.
D
B T1 timer (35 ± 5 sec.) elapsed without
detecting 300 bps signal.
Recording paper jam.
Timing Sensor abnormal.
Recording paper jam.
Timing Sensor abnormal.
Recording paper jam.
Paper Exit Sensor abnormal.
Paper Tray is opened.
No recording paper or paper is not set
properly.
No Paper Sensor is defective.
Connector is not installed properly.
Transmitter Document Jam.
Paper size is incorrect.
Document is not set properly.
Defective Read Point Sensor.
The document may jam.
Defective Read Point Sensor.
No toner.
Defective Low Toner Sensor.
Toner is getting low.
Defective Low Toner Sensor.
Toner Cartridge has not been installed.
Defective Toner Cartridge Sensor.
Cover is not firmly closed.
Connectors are not firmly connected.
Door is not firmly closed.
Connectors are not firmly connected.
2nd G3 PCB is defective.
Incorrect number was dialed and the
START button was pushed.
Telephone line was disconnected while
dialing.
SC PCB or
Receiver is defective. (It may only be
transmitting CED)
131
DP-1910F
Cause
MJR PCB is defective.