Service Modes (For Facsimile) - Toshiba e-studio191f Service Manual

5.2.

Service Modes (For Facsimile)

Caution:
The factory default parameters are preset (country dependent) for optimum performance and in
compliance with the local telecommunication regulations/standards, and do not need to be changed.
Changing some of these parameters may cause the unit to be no longer compliant or become
inoperable.
5.2.1. Fax Service Mode Procedure
1. To enter the Fax Service Mode
a. Press the "Function" and the "7" keys.
b. Press the "Monitor" key four times.
c. Press the "* (Tone)" key.
d. Input the ID, and press the "Set" key to enter the Service Mode (default ID is 00000000).
e. Enter the desired code number, or press the "
2. To exit the Fax Service Mode
Press the "Stop" key.
Note:
The following buttons provide these functions in the Service Mode:
"Start" : The new setting value is stored in the machine.
" " : Scroll the function parameter number down.
" " : Scroll the function parameter number up.
5.2.2. FAX Service Mode Table
The following service modes are provided to assist you in setting operational functions of the unit and
determining the condition of the unit.
No. Service Mode
00 Not Used
01 PARAMETER SET
02 RAM EDIT MODE
03 PRINT REPORT / LIST
04 MODEM TEST
05 Not Used
06 RAM INITIALIZE
07 Not Used
08 CHECK & CALL
09 SYSTEM MAINTENANCE
10 FIRMWARE VERSION
", "
Allows changes to the function parameters (the home position,
etc.).
Factory use only.
Prints the Function Parameter List, Page Memory Test, Printer
Report, All Document File, Protocol Trace and Toner Order Form.
Generates various binary, tonal and DTMF signals, by the modem.
Initialize RAM and restore the default value of the function
parameters.
Note: Unplug the power cord, replug it into outlet to enable the
parameter settings.
Allows input of information for Service Alert Report, Maintenance
Alert Report and Toner Order Form.
Used for Firmware Update, Parameter Restore, Parameter Backup
and Sending a Received File during a fatal printer error.
Displays Firmware Version for SC, SC Boot, Panel, etc.
162
" keys.
Description
DP-1910F