Toshiba e-studio191f Service Manual page 39

<Feed Roller>
(15) Remove the Snap Ring.
(16) Remove the Feed Lever (402).
(17) Remove the Feed Roller Shaft Assembly.
(18) Remove the Feed Roller (411).
Note:
When reinstalling, make sure that the Roller Assembly
is properly placed on the ADF Unit.
[4. CIS (Contact Image Sensor) Assembly]
(1) Open the ADF Cover Assembly.
(Refer to 2.3.1. [4.Top Cover])
(2) Remove the Stamp Unit.
(Refer to 2.3.2. [2.Stamp Unit])
(3) Remove the Upper Paper Guide (311).
(Refer to 2.3.2. [3.Roller Assembly])
(4) Remove 3 Screws.
(5) Remove the Paper Guide (434).
(6) Remove 2 Screws.
(7) Remove the Paper Guide (433).
(8) Remove 2 Screws.
(9) Remove the CIS Assembly.
(10) Disconnect the Flat Harness from CIS Assembly.
Caution:
When reinstalling the CIS Assembly, pull out the Flat
Harness a little from the machine first.
After connecting, push the Flat Harness in the
machine.
39
DP-1910F