Table of Contents
Advertisement
Q4. How to use the WDS Bridging function to extend my wireless
network?
For
example, my house covers a large area. The wireless network coverage of the router
I'm using (the root router) is limited. I want to use an extended router to extend the
wireless network of the root router.
Note:
•
WDS bridging only requires configuration on the extended router.
•
WDS bridging function can be enabled either in 2.4GHz frequency or 5GHz frequency for a dual-band router. We
use the WDS bridging function in 2.4GHz frequency as example.
1. Visit http://tplinkwifi.net, and log into with the username and password you set for
the router.
2. Configure the IP address of the router:
1 ) Go to
Advanced
router to be in the same subnet with the root router; (For example, the IP
address of the root router is 192.168.0.1, the IP address of the extended router
can be 192.168.0.2~192.168.0.254. We take 192.168.0.2 as example.)
2 ) Click Save.
Note: Log into the web management page again if the IP address of the router is altered.
3. Survey the SSID to be bridged:
1 ) Go to
Advanced
WDS
section, click
2 ) Click Survey, locate the root router's SSID and click
LINK_2512 as example).
3 ) If the root router has wireless password, you should enter the wireless password
of the root router.
4 ) Click Save.
>
Network
> LAN, configure the IP address of the extended
>
System Tools
>
System Parameters
Enable WDS
Bridging.
and focus on the
2.4GHz
Choose
(Here we take TP-
106
Hide quick links:
Advertisement
Table of Contents
