Outside Vertical Installations - HAMPTON BAY greenfire gci60 Technical Manual

o v i
utSide ertical nStallationS
To accomplish an outside vertical pipe installation, follow the "H
section and then finish it by performing the following.
1. Install a tee with clean out on the outside of the house.
2. Install PL vent upward from the tee. Make sure that you install support brackets to keep the vent
straight and secure. All joints in the exhaust venting system must be fastened with at least three (3)
screws.
3. Install ceiling thimble and secure the flashing as you go through the roof.
4. Ensure that the rain cap is a minimum of 24" (61 cm) above the roof.
NOTE - This venting configuration is only for use with the Built-In installation.
Hampton GCI60 Cast Pellet Insert Technical Manual
Installation
:
Rain cap
Figure 13: Outside Vertical Installation.
E t
orizontal xHaust HrougH
24"
(61 cm)
Flashing
3" (7.5 cm)
Clearance
Support
bracket
Tee with
cleanout
Type "L"
vent
W i "
all nstallations
19