Oversize Filler Panel (Part # Gci60-918); Thermostat Installation - HAMPTON BAY greenfire gci60 Technical Manual

o f p
verSize iller anel
1. If installing the Oversize Filler Panel (50"W x 38"H), do so before sliding unit into place.
2. Secure the filler panel to the backside of the cast faceplate using the 10 x #8 - 32 x 3/8" Thread
Rolling Screws.
t i
hermoStat nStallation
Figure 4: Thermostat connection wires.
10
Installation
( # gci60-918):
part
:
1. Install the wall thermostat (millivolt rated thermostat
recommended, or a 12/24 Volt rated thermostat set to
millivolts) in a location that is not too close to the unit
but will effectively heat the desired area.
2. Connect the Thermostat or Timer to the thermostat
wires on the unit. (Fig. 4)
If the heat in the room becomes too great, the high limit
switch may turn the stove off and the switch will have to
be manually reset. To reset the high limit switch:
-open the hopper lid
-remove plug under control panel
-use screwdriver to press down on the button on top of
the snap disk switch
Hampton GCI60 Cast Pellet Insert Technical Manual