Rear Brake - Canyon Speedmax CF SLX Manual

46 THE BRAKE SYSTEM
Mount the new brake pad together with the
brake pad holder as well as the spacers and
bolt in the same order and orientation as you
dismounted them previously.
Re-mount the front wheel.
Make sure that the brake pads are oriented
correctly to the braking surface of the rim. For
more information read the chapter "Checking
and readjusting road bike brakes" in your bicy-
cle manual road bike.
Always tighten the clamp bolts of the brake
pad holders to the indicated torque value of
5 to 7 Nm.
Check the adjustment of the brakes as de-
scribed above.
Re-mount the brake cover. Tighten the clamp
bolts to the indicated torque value of 2 Nm.
Make sure that the clamp bolts are provided
with thread lock ("Loctite", medium strength).

REAR BRAKE

Unscrew the clamp bolts of the brake cover
and remove the brake cover.
Check whether the triangular cable holder is
positioned correctly: its guide must run in the
rail and the lasered line must be positioned
within the range marked on the brake arms.
THE BRAKE SYSTEM
Correct the position of the cable holder, if
necessary by means of the respective ca-
ble adjuster through which the brake cable
comes out of the frame. If the cable adjuster
is too tight, you may use a small Allen key.
If its adjustment range is not sufficient, undo
the two clamping bolts at the cable holder and
correct the cable adjustment. Then tighten
the two clamping bolts to the indicated torque
value of 2.5 Nm.
47