Canyon Speedmax CF SLX Manual page 30

56 ADDITIONAL ACCESSORIES
Insert further threaded sleeves from below
into the offset spacers and mount further
spacers, the clamping pieces of the exten-
sions and the armrests, as described in the
chapter "Adjusting extensions and armrests".
TEAM SWITCH PLATE SET
With the "Team Switch Plate Set" you can
shift the armrests in several positions to the
side and to the rear. All necessary working
steps and instructions are given in the chap-
ter "Adjusting extensions and armrests".
Insert the "Team" spacers directly under the
armrests and fasten the spacers with the
suitable threaded sleeves and clamp bolts.
Observe the indicated torque values.
Place the armrests in the desired position on
the "Team" spacers and fasten the armrests,
as described in the chapter "Adjusting exten-
sions and armrests". To do so use the special
countersunk bolts supplied and tighten them
to the indicated torque value of 3 Nm.
ANGLED SPACER KIT
With the "Angled Spacer Kit" you can change
the inclination of the extensions and the arm-
rests by 9 degrees upwards. All necessary
working steps and instructions are given in
the chapter "Adjusting extensions and arm-
rests".
Position the angled spacers directly under the
extensions and fasten the spacers and the
"Angled Spacer Kit".
ADDITIONAL ACCESSORIES
If necessary, use the supplied shorter thread-
ed sleeves and clamp bolts and observe the
indicated torque values.
Position the clamping pieces of the exten-
sions on the pressfit threaded sleeves of the
angled spacers and mount the armrests, as
described in the chapter "Adjusting exten-
sions and armrests".
57