Canyon Speedmax CF SLX Manual page 10

16 ASSEMBLY FROM THE BIKEGUARD
Make sure the spacers are correctly aligned,
i.e. the slot for the Di2-cable should be on the
rear.
Put the clamping piece of the extensions un-
der the top 5-mm-spacer. Insert the narrow
red lock rings between the clamping piece
and the armrest.
Position the armrest in centred position on
the top spacer, insert the clamp bolts and
tighten them to the indicated torque value of
5 Nm.
Check the firm seat of the armrests.
Mount the extensions on the other side in the
same way.
Finish by fixing the pads with the Velcro fas-
tener to the armrests.
FRONT WHEEL MOUNTING
Take the front wheel and take off both protec-
tive caps from the front wheel axle.
Take the quick-release for the front wheel out
of the small parts box. Release the counter-
nut and remove one of the springs from the
quick-release.
ASSEMBLY FROM THE BIKEGUARD
Insert the quick-release into the hollow front
wheel axle. Make sure there is one spring on
either side of the hub.
When mounting the springs on either side
of the quick-release, make sure their small-
diameter ends face the hub.
The quick-release lever is mounted to the left
side, i.e. opposite the chain drive. For more in-
formation on quick-releases read the chapter
"How to use quick-releases and thru axles" in
your bicycle manual road bike.
More details on wheel mounting are
i
given in the chapter "The wheels" in
your bicycle manual road bike.
17