Synchronising The Front Brake; Rear Brake - Canyon SPeedMax CF Instructions Manual

48 ThE BRAKE SYSTEM

SYNCHRONISING THE FRONT BRAKE

Operate the front brake several times while
the bike is in the stand and then check the
clearance between the brake pads and the
rim.
If the clearance differs, turn back the set-
screws for synchronisation in the fork blades
until they are flush on the outside. From this
starting position you may screw in the set-
screws by a maximum of five turns.
The screwing in of one of the setscrews has
the effect that the brake pad is moved away
from the rim on this side and the one of the
opposite side is brought closer to the rim. The
correct position has been reached once both
brake pads have the same clearance from the
rim.

REAR BRAKE

Release the clamping bolts of the Brake-
booster and remove the Brakebooster.
Remove the rear wheel to check the brake.
Insert the Canyon Brake Adjuster; it may also
be necessary to pull the rear brake.
ThE BRAKE SYSTEM 49
Now take off the small spring.
Check that the Canyon Brake Adjuster is sit-
ting correctly: the clamping piece must lie
flush against the upper edge of the Canyon
Brake Adjuster.