Table of Contents
Advertisement
22
EXTERNAL BATTERY – KIOX DISPLAY
EXTERNAL BATTERY – REMOVAL
Switch off the system.
Use the key to unlock the battery.
Carefully tilt the battery away from the down tube
and take it out of the bottom holder.
EXTERNAL BATTERY – INSTALLATION
Carefully place the battery in the bottom hold-
er on the down tube. Tilt the battery toward the
down tube and push it into the holder at the top
until you hear it click in.
KIOX DISPLAY
Some models with Bosch drive are equipped with
a KIOX display. This display is held in place by
magnets.
When you park your Canyon pedelec, you can
remove the KIOX display by pulling it out of the
holder, toward the front and up.
The display can be mounted to the
holder with a screw to protect against
theft. For more information read the BOSCH
KIOX operating instructions or use our service
hotline or the contact form on our website,
www.canyon.com
ADJUSTING THE INTEGRATED BRAKE LEVERS
ADJUSTING THE
INTEGRATED BRAKE
LEVERS
The PRECEDE:ON allows to adjust the tilt and po-
sition of the brake levers to the needs of the rider.
To change the tilt and/or position of the brake
levers, first slightly pull back the respective brake
lever cover.
These covers are located on the underside of the
handlebar.
1
2
The screws are marked "1st" (1) and "2nd" (2).
1
2
Undo the screw marked "2nd" (2) on the respec-
tive brake lever with a 3 mm Allen key. Be careful
not to undo both screws fully, as otherwise the
cover and the brake lever itself would come off
the handlebar.
You can now move the brake lever slightly up or
down. At the same time, you can also move the
brake lever slightly outward toward the handlebar
grip or inward toward the centre of the handlebar.
After adjusting the brake lever to the desired po-
sition, retighten the screw marked "2nd" (2) to
2 Nm torque. Now check both screws for tight
seat. Use a torque wrench and do not exceed the
torque values specified by Canyon.
For more information read the chapter "Adjusting
the Urban bike to the rider" in your Canyon bicycle
manual Urban Bike.
Some pedelec models are equipped
with "ergon"-brand GA3 grips. For more
information on these grips see your Canyon
bicycle manual Urban Bike.
For general information on adjusting
brake levers, read the chapter "Shifter
and brake lever adjustment" in your compre-
hensive world-specific Canyon bicycle manual.
For more information on adjusting the
reach of the brake levers read the chap-
ter "Adjusting the brake lever reach" in your
comprehensive world-specific Canyon bicycle
manual.
23
Advertisement
Table of Contents
