Adjusting Extensions And Armrests - Canyon Speedmax CF SLX Manual

34 ADJUSTING THE CANYON SPEEDMAX CF SLX TO THE RIDER
The Canyon Speedmax CF SLX is available
with two stems of different lengths, three
handlebar versions and five different exten-
sions:
Stem length: 65 or 85 cm.
Handlebar: "Rise" (grip position 50 mm
higher), "Flat" (0 mm) or "Drop" (40 mm
lower). Handlebar width of all three ver-
sions: 410 mm.
Extensions: "L-Bend", "S-Bend" and
"Straight" (all made of carbon) as well as
"J-Bend" and "Lazy S-Bend" (made of alu-
minium).
Handlebars and stems must be replaced by
Canyon only. If you are not happy with your
handlebar and/or seating position, contact
our service hotline at +44 208 5496001.
For more information on the respec-
i
tive forms see our website at
www.canyon.com

ADJUSTING EXTENSIONS AND ARMRESTS

The height of the extensions and the armrests
can be adjusted by various arrangements of
the clamps for the extensions and the sup-
plied spacers in 5 mm steps.
Do not stack more than three spacers on top
of one another on each side, they should not
be higher than 80 mm.
In choosing the threaded sleeves
and clamp bolts make sure in any
case that the clamp bolts have to be
screwed in by 20 full turns into the thread-
ed sleeves at least. Risk of breakage!
ADJUSTING THE CANYON SPEEDMAX CF SLX TO THE RIDER
In case you want to mount the extensions at
a lower height, you can use the respectively
shorter threaded sleeves and clamp bolts.
Special spacer kits are also available as ac-
cessory ("Switch Plate", "Team Switch Plate"
and "Angled Spacer"); these are intended
to adjust the position of the extensions and
armrests to the individual needs. For more
detailed information read the chapter "Addi-
tional accessories".
If you want to change the height of the exten-
sions or use one of the specific spacer kits,
remove the foam paddings from the armrests
first. Unscrew the clamp bolts of the exten-
sions on the left side of the handlebars entire-
ly and remove the armrest, the spacers and
the extensions including connecting rings,
except from the two bottom connecting rings
which remain on the handlebars.
If necessary, also replace the threaded
sleeves by shorter or longer ones, according
to the desired overall height of the spacers.
Then insert spacers and connecting rings al-
ternately until you reach the desired height.
Make sure the spacers are correctly aligned,
i.e. the slot for the Di2-cable should be on the
rear.
35