Canyon Speedmax CF SLX Manual page 29

54 ADDITIONAL ACCESSORIES
TOOLBAG
Under the tool-free removable top tube cover
there is a small bag containing all necessary
accessories to repair a puncture.
Toolbag contents: spare tube, tyre lever, CO2
adapter, CO2 cartridge (2)
REPLACING THE SEAT POST
If you want to exchange the standard seat
post against the "TT" version, release the Al-
len bolt at the seat post clamp on the upper
side of the top tube.
Now the released seat post can be removed
from the frame. Do not use brute force, if the
seat post does not move easily inside the seat
tube. Contact, if necessary, our service hot-
line at +44 208 549 6001.
Undo the two Allen bolts which clamp the sad-
dle slide to the seat post and unscrew them
completely. Remove the saddle slide from the
seat post and position it on the "Carbon Seat-
post TT". Make sure that the pointed end at
the top of the seat post is oriented towards
the rear contrary to the direction of motion.
Fasten the saddles slide clamp mechanism on
the seat post, as described in chapter "Fore-
to-aft-position and saddle tilt". In this chapter
you also find all further steps to adjust the
best seating position.
ADDITIONAL ACCESSORIES
SWITCH PLATE KIT
With the "Switch Plate Kit" you can shift the
extensions and the armrests by 15 mm in-
wards or outwards. All necessary working
steps and instructions are given in the chap-
ter "Adjusting extensions and armrests".
Replace the standard spacers by the offset
spacers in the desired position and fasten
them with the supplied shorter threaded
sleeves and clamp bolts. Observe the indi-
cated torque values and make sure that the
clamp bolts are screwed in by 20 full turns
into the threaded sleeves at least.
55