Canyon Speedmax CF SLX Manual page 20

36 ADJUSTING THE CANYON SPEEDMAX CF SLX TO THE RIDER
Use the narrow red terminating rings between
the top spacer and the armrest.
In the case of the handlebar model "Drop", the
extension clamp can also be mounted under-
neath the handlebars. Do not forget to insert
the connecting rings.
The armrests can be mounted lengthways in
three different positions and sideways in two
different positions.
Insert the suitable clamp bolt and tighten it to
the indicated torque value of 5 Nm.
ADJUSTING THE CANYON SPEEDMAX CF SLX TO THE RIDER
Check the firm seat of the armrest and change
the height of the extension on the right han-
dlebar side in the same way.
Check again that the extensions sit correct-
ly in their clamps: The plastic cover with the
outlet opening for the Bowden cable should
be flush in the rear or project within the in-
dicated adjustment range from the clamp to
the rear.
Make sure the shifters are in proper align-
ment.
Finish by fixing the pads with the Velcro fas-
tener to the armrests.
Make a test ride to check the seating position.
Once you have determined the final seating
position, loosen the clamp bolts once again.
Apply some thread lock (medium strength)
on the threads of the clamp bolts and tighten
them to the indicated torque value of 5 Nm.
Make sure that you only clamp the extensions
within the marked area ("End of clamping
area").
37