Adjusting Extensions And Armrests - Canyon SPeedMax CF Instructions Manual

34 AdjUSTING ThE CANYON SPEEdMAx CF TO ThE RIdER
do the clamping bolts up to the prescribed
tightening torque of 5 Nm.
Position the handlebars so that they are cen-
tred on the stem and that the four holes for
the clamping bolts line up.
Ensure that the Bowden cables and shifter
cables do not get twisted or kinked, that they
have smooth radii and are not pinched be-
tween the handlebars and the stem.
Insert the conical inserts of the front clamp-
ing bolts.
AdjUSTING ThE CANYON SPEEdMAx CF TO ThE RIdER
Apply a little locking paste (medium strength)
to the threads of the clamping bolts and tight-
en them up alternately to the specified tight-
ening torques (front M4 bolts: 4 Nm; rear M8
bolts: 5 Nm).
Put the cover of the stem in place and tighten
up its clamping bolts to the prescribed torque
of 2 Nm.

ADJUSTING EXTENSIONS AND ARMRESTS

The handlebars and extensions offer a wide
variety of adjustment options. You can choose
between handlebars without drop and han-
dlebars with 42 mm drop. The height of the
armrests can also be changed by using ad-
ditional 5 mm spacers. In both versions the
width of the handlebars is 420 mm.
The height of the extensions and the armrests
can be adjusted by various arrangements of
the clamps for the extensions and the sup-
plied spacers in 5 mm steps.
A maximum of three spacers on top of one an-
other may be used here.
35