Setting Up The Scales - Adam Equipment WSK 8 User Manual

SETTING UP THE SCALES

• Remove the Indicator from its box and fix it to the U shaped bracket
using the 2 x fixing handles. Take the Indicator and place it onto the
pillar ensuring the slack cable is pushed inside. Fix the Indicator to
the pillar using the screw provided.
• Remove all upper internal packaging, place the pillar into the base
bracket fitting and remove the complete machine from the box.
Remove any plastic bags that may have been used for protection.
• Fix the pillar to the base bracket fitting using the screws provided
• Adjust the viewing angle of the Indicator to the ideal position and
tighten the 2 x locking handles.
• Level the scale by adjusting the five feet on the WSK/WBK or the
four feet on the WFK/WLK until the bubble is in the centre of the
level indicator. If the scale rocks, re-adjust the feet.
NOTE: Use of a food-safe grease is recommended on the threaded part
of the feet to keep them turning freely.
• Attach the power input connector to the indicator, plug in and turn
on the external power supply and press the [On/Off] key. The
software revision number will be displayed followed by a self-test
showing all digits before the zero is displayed along with the unit of
weight that was last used.
• Optional connections to RS232 port and relay wiring port should be
made if required.
Page 5