• The number of decimal points will depend on the weight used in
comparison to the capacity of the system. A smaller weight will show
only "100%" while a larger weight might show "100.00%".
• If the scale was showing zero weight when entering this function, then
the user must manually enter the weight to be set as 100% as described
below.
• Press the [
• Press [
0/T
accept a value the user enters as the reference weight.
• Enter the value using the [Unit/ ] key and [Pcs/ ] key to select and set
the value of the 100% mass.
• When set, press the [
show "0.00 %".
• Press [Unit/ ] to return to weighing.
] key. "P1 PCt" will be displayed.
0/T
] again to enter percent weighing. The scale will now
0/T
] key to store the value. The display will
Page 15