Hyundai CRMD 7222 SU Instruction Manual page 127

Mounting Sleeve Installation
1) Slide the mounting sleeve off the chassis. If it is locked into position, use the removal tools
(supplied) to disengage it.
2) Check the dashboard opening size by sliding the mounting sleeve into it.
If the opening is too small, carefully cut or file as necessary until the sleeve easily slides
into the opening. Do not force the sleeve into the opening or cause it to bend or bow. Check
for sufficient space behind the dashboard for the unit chassis. This unit can be installed
in any dashboard with a suitable 183 mm (W) x 53 mm (H) opening as shown above. The
dashboard should be 4.75 mm - 5.56 mm thick in order to be able to support the unit.
3) Locate the series of bend tabs along the top, bottom, and sides of the mounting sleeve. With
the sleeve fully inserted into the dashboard opening, bend as many of the tabs outward as
necessary to firmly secure the sleeve to the dashboard..
CAUTION:
For proper operation of the DVD player, the chassis must be mounted within 20 of horizon-
tal. Make sure the unit is mounted within this limitation..
4) Place the unit in front of the dashboard opening so the wiring can be brought through the
mounting sleeve. Follow the wiring diagram carefully and make certain all connections are
secure and insulated with wire nuts or electrical tape. After completing the wiring connecti-
ons, turn the unit on to confirm operation (vehicle ignition must be on). If the unit does not
operate, re-check all wiring until the problem is corrected.
5) Make sure the radio is right-side up, then carefully slide the radio into the mounting sleeve
until it is fully seated and the spring clips lock it into place.
6) Secure the rear of the unit to the car body using the mounting bolt and rubber cushion.
7) Test the unit using the "Operation" instructions that follow..
Kit Installation
I f your vehicle requi res the use of an installation kit to mount this unit, follow the instructions
included with the installation kit to attach the unit to the mounting plate supplied with the kit.
1) Wire and test the unit as outlined in the Mounting Sleeve Installation instructions.
2) Install the radio/mounting plate assembly to the sub-dashboard according to the instructions
in the installation kit.
3) Replace the dashboard trim panel.
ISO Installation
This unit has threaded holes in the chassis side panels which may be used with the original
factory mounting brackets of some vehicles to mount the radio to the dashboard.
Please consult with your local car stereo shop for assistance on this type of installation.
1) Remove the existing factory radio from the dashboard or center console mounting. Save all
hardware and brackets as they will be used to mount the new radio.
2) Carefully unsnap the plastic frame from the front of the new unit chassis. Remove and dis-
card the frame..
ENG - 127
ENG