Shibaura ST450 Operator's Manual page 37

5. Fuel Gauge
Indicates the amount of diesel fuel remaining in
the tank. The gauge is activated when the key
switch is in the "ON" or "HEAT" positions. It will
register empty with the key switch in the "STOP"
position.
6. Flasher Hazard Warning Lights
Flash the both allow when the hazard light switch
is "ON" positioned.
7. Flasher Turn Signal Lights
Operate when the turn signal switch is activated.
Rotate the switch to the right for right turns, the
right arrow will flash. Rotate the switch to the left
for left turns, the left arrow will flash. The flasher
turn lights can be activated with the key switch in
any position.
8. Temperature Gauge
Indicates coolant temperature. It is activated
when the key switch is turned to the "ON" or
"HEAT" positions. The gauge will register cold
with the key switch in the "STOP" position. If the
needle registers in the green range of the gauge,
this indicates a normal operating temperature. If
the needle moves to the red portion of the gauge,
this indicates an overheated condition. Stop the
tractor engine immediately and investigate the
cause.
9. Tachometer
Registers engine RPM (Revolutions Per Minute).
The gauge is marked in increments of 100 and
will return to zero when the engine is not running.
10. Rear PTO Speed
Determined by the position of the needle on the
tachometer. The tachometer is marked to
indicate 540rpm PTO speed.
Your tractor is equipped with 2-speed PTO so
that the symbol of "540" on the proof-meter
relates to 540rpm PTO speed with lower PTO
speed gear is selected, and "540E" symbol
relates to 540rpm PTO speed with higher PTO
speed gear is selected.
Engine RPM should remain close to this mark
while using the rear PTO; running the engine
faster than these results in a dangerous over
speed condition.
SECTION 2 – OPERATION
11. High Beam Indicator
Illuminates when the, head-lights are switched to
main beam.
12. Parking Brake Light
Illuminates if the parking brake is engaged when
the key switch is turned from "OFF" position.
13. Hazard Indicator Warning Lights
Flash in unison with the flasher hazard warning
light when the hazard lights switch is "ON"
positioned.
14. PTO Indicator Light
Illuminates with the key switch in the "ON"
position and the PTO control switch is "ON"
positioned.
15. Trailer Flasher lights burn out indicator
Flash in unison with the flasher turn lights, when
burn out or wire breaking the flasher lights of
trailer, which connected with ELECTRICAL
SOCKET of tractor, and flasher switch is turned
on.
Also, flash in unison with the flasher lights, when
ELECTRICAL
connected with trailer, and flasher switch is
turned on.
16. HST High Speed Indicator Light
Illuminates with key switch in the "ON" position
and when the HST speed control is high
positioned.
2-5
SOCKET of tractor is not