Alternator - Shibaura ST450 Operator's Manual

ALTERNATOR

The tractor's 55-amp alternator (1) in Figure 3-32,
is belt-driven from the engine crankshaft pulley. It
is important that belt slippage does not occur, or
the charging system will be adversely affected.
To adjust the belt, see the instructions previously
given under "Fan Belt" section (page 3-19).
Other than belt adjustment, the only alternator
maintenance required is to periodically inspect
the terminals to ensure they are clean and tight.
The alternator-cooling fan should also be cleaned
periodically.
When working on or checking the alternator,
adhere to following precautions or alternator
damage may occur:
• Do not UNDER ANY CIRCUMSTANCES
short the field terminal of the alternator to
ground.
• Do not disconnect the alternator output lead
or battery cables while the alternator is
operating.
• Do not remove the alternator from the tractor
without first disconnecting the negative (-)
battery cable. When removing the battery,
disconnect the negative (-) cable first.
• To install a battery, MAKE SURE that the
positive (+) cable is connected first and that
the negative terminal is connected to ground.
Reverse polarity will destroy the rectifier
diodes in the alternator.
If the battery charge warning light illuminates,
indicating that the alternator is not charging the
battery, check the fan belt and the wiring
connections. If these items are in satisfactory
condition and the warning light continues to
indicate no charge, consult your SHIBAURA
Dealer.
SECTION 3 – LUBRICATION AND MAINTENANCE
3-21
Figure 3-32