Safety Instructions - Eneo VKC-1327A/WDDG1 Installation And Operating Instructions Manual

1. Safety Instructions

• Please read these safety and operating instructions before putting the camera into operation.
• Keep the manual in a safe place for later reference.
• Never operate the camera outside of the specifications as this may prevent the camera functioning.
• The cameras should never ointed with open iris towards the sun. (This can damage the sensor).
• Pay attention to safety when laying the connection cable and ensure that the cable is not subjected to heavy loads
or damage and that no moisture can get in.
• Protect your camera from contamination with water and humidity to prevent it from permanent damage.
Never switch the camera on when it gets wet. Have it checked at an authorized service center in this case.
• To disconnect the power cord of the 30VAC cameras, pull it out by the plug. Never pull the cord itself.
• Never open the device.
The warranty becomes void if repairs are undertaken by unauthorized persons.
• Maintenance and repair have to be carried out only by authorized service centers.
• Operate the camera only at a temperature range of -0°C to +40°C and at a humidity of max. 90%.
• The camera is equipped with an automatic gain control (AGC) which increases the sensitivity at low light levels.
Noisy pictures at these conditions are quite normal.
• Pictures including bright spotlights will cause perhaps vertical lines (smear) or soft edges (blooming) on the
monitor display. This happens most probably in automatic shutter mode (ESC).
This is not a defect but an effect caused by the CCD sensor.
• Be sure to put a silica-gel bag into the housing to avoid humidity due to temperature variance between inner and
outside of housing
• Contact your local dealer in case of malfunction.
• The warranty becomes void if repairs are undertaken by unauthorized persons. Do not open the housing.
• Installation, maintenance and repair have to be carried out only by authorized service centers. Before opening the
cover disconnect the unit from mains input.
• Only use original parts and original accessories from Videor E. Hartig GmbH.
• Use only a mild detergent to clean the housing.
Never use dilution or gasoline for this can cause permanent damage to the surface.
NOTE: The upper section of the housing may only be separated from the lower section by removing the
4 screws
NOTE: This is a class A digital device. This digital device can cause harmful interference in a residential
area; in this case the user may be required to take appropriate corrective action at his/her own
expense.