Mounting The Wddg Housing; Connection Assignment - Eneo VKC-1327A/WDDG1 Installation And Operating Instructions Manual

4. Mounting the WDDG2 Housing
Note
B
Screw holes
W
Back of housing
Note
G
Housing cap
Connection cable
K Cable feed

5. Connection Assignment

The following connectors are mounted on the „eneo camera packages", which are supplied with system cables
(video/DC):
Video output:
BNC jack (white)
Power supply:
Adapter bushing (green), for VDC/4VAC
K
W
G
Teflon
strip
The operational side of the camera is mounted in the housing.
Prepare the mounting site for installation.
Loosen the 4 Torx screws on the housing, but do not completely remove them, and
remove the cap.
Mark the position of the back of the housing W on the surface on which the device
is to be mounted. The screw holes B in the back of the housing W may be used as a
template.
Fix the back of the housing W on the desired surface (plug and cross-head screws are
enclosed) and feed through the cable. /3" or /" opening.
When mounting on a ceiling, the camera must be installed within the housing.
Fasten housing cap G on the back of the housing.
After connecting the power supply and attaching the coaxial cable to an appropriate
monitor, the camera is operational.
/3" and /" socket. The /" high-strength cable gland is included in the accessori-
es. A dummy plug for the /3" socket is included.
Polarity of the DC plug
for all 12VDC cameras
4
Wall / ceiling
B