SSANGYONG 2010 Kyron User Manual page 216

2. Place the jack directly under the jack-up points so that the
top of the jack contacts the vehicle at the jack-up point.
WARNING
Do not attempt to raise the vehicle until the jack is set up at the
jack up point. Do not use the jack on a tilted or soft surface. Make
sure that the jack securely contacts the jacking point of the ve-
hicle and the ground. Otherwise, there could be a personal injury
or damage to your vehicle.
CAUTION
Do not set the jack at any other position on the vehicle other than
those specified. If the jack is set at the wrong position, the body of
the vehicle could be dented or damaged. The top of the jack should
contact the jacking point.
WARNING
• Do not attempt to raise the vehicle until the jack is in the proper
position, and secure both to the vehicle and the ground.
Otherwise, the vehicle can fall out of the jack and you may in-
jured by it.
• The jack should be installed perpendicular to the vehicle frame.
If it is not, the vehicle can fall out of the jack and you may se-
verely injured.
• Never get under the vehicle while the vehicle is supported by jack.
• Do not lift the load over 1,300 kg with the jack.
CAUTION
Do not directly install the jack to the vehicle. Its upper plate should
be perpendicular to the frame.
<Jack up points>
Make sure to install the jack so that its upper plate is cor-
rectly seated under the vehicle's positions marked in the
figure for the flat tire side.
IN CASE OF EMERGENCY
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
12-9