Changing The Engine Oil - Champion 100136 Operator's Manual

Model 100136
MAINTENANCE
DO NOT overfill the engine with engine oil. Damage to the
engine may occur.
4. Remove the dipstick. The oil level should be at the FULL
mark. If necessary, add oil. DO NOT overfill.
5. Install the dipstick.
6. Turn the engine control module switch to its prior position.

CHANGING THE ENGINE OIL

!
Always wear protective glasses
or goggles and protective clothing
when changing hot engine oil.
1. Turn the ATS to the OFF position.
2. Turn the engine control module switch to the MANUAL
position.
3. Allow the engine to run until it reaches operating
temperature.
4. Turn the engine control module switch to the OFF position.
24
Part No. 101306 Rev. A
NOTICE
Figure 12
WARNING
NOTICE
Always be environmentally responsible. Consult the local
authorities or reclamations facility for proper disposal of
engine oil waste.
5. Position drain pan under alternator.
6. Loosen hose clamp on oil drain hose and slide drain hose
off retaining pin. (Figure 13)
3
2
Figure 13
1. Oil Drain Hose
2. Hose Clamp
7. Position drain hose into drain pan and allow crankcase to
empty.
8. With the oil drained, remove oil filter by turning
counterclockwise.
9. Apply a light coat of clean engine oil to the gasket of the
new oil filter.
10. Screw the new oil filter on (turning clockwise) by hand
until the gasket contacts the engine block.
11. Screw the filter an additional 3/4 turn.
12. Reinstall the hose onto the retaining pin and reposition
hose clamp.
13. Fill the engine with the proper amount of engine oil. See
Figure 12.
14. Turn the engine control module switch to its prior position.
15. Turn the ATS to the AUTO position.
1
3. Retaining Pin