Ir Connection - Russound XStream X5 Installation Manual

IR Connection

Common IR Output
The common IR output is supported by the IR engine and programming tool in SCS. This comprehen-
sive list of universal source codes and learning IR capabilities supports the controller features built
into the X5. They are also carried by the keypad IR receiver and allows for use of the USRC hand held
remote control. There is an IR receiver located on the front panel of the X5 for learning IR commands.
See SCS software for more details on setting universal codes, learning commands or building Macros
to control source devices connected to the X5.
12V Trigger Cable
12V Trigger Cable
Attach the end of the IR emitter with the 3.5mm plug to the IR emitter port. Remove the adhesive
back at the other end of the emitter and attach the emitter over the source component's IR window.
In order to control the connected source component with IR, the source must be selected at the key-
pad or the app receiving the command. See the diagram below.
IR emitter
Russound
845.1
857
Connecting
Block
59